Baumer NE218 Manual de usuario Pagina 34

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 44
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 33
NE218
34 www.baumer.com
No code number is set at the factor, and therefore this code request
can be skipped by pressing the key. The code is set in program-
ming line 40. After a code has been set, the programming level can
only be called by entering the correct code.
Incorrect code If an incorrect code has been input:
appears in the display when the key is pressed.
After 15 seconds, the system will automatically revert to the
operating mode.
Press the
key.
Input the correct code.
Correct code unknown If the correct code is not known:
Return the counter to the factory.
Correct code When the correct code has been input, press the
key.
The programming segments are now called up in succession.
Programming field 1
Here all operating parameters can be selected and changed. The
operating parameters that are blocked for the operator are also dis-
played.
Press the
key again.
The operating parameters are now called up.
The respective LED flashes.
Line 1 XP - Main counter (current counter status)
Line 2
P1 - Preset value 1
Line 3
P2 - Preset value 2
Line 4
SC - Start count
Line 5
Σ - Totalizer
Line 6
- Time meter
Line 7
SF - Scaling factor
Vista de pagina 33
1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 43 44

Comentarios a estos manuales

Sin comentarios